mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

. Cylinder headl installed Removal, installation 1 Put piston of the relevant cylinder on ignition TDC. Note The respective pistons are in the ignition TDC position, when the markings on vibration damper shown in the adjacent drawing are beneath the TDC pointer. PO3-0058-13 Marking I TDC I 180” Piston at TDC on cylinder I 1 and 4 I 2 and 3 2 Removal and installation of oil pipe (67). 3 Remove and install the required rocker arm bearing support (61) tightening torque 20 Nm. Installation note Before installing rocker arm bearing support lubricate camshaft journals.

Install the rocker arm bearing support so that the support area for the oil pipe points rearwards and the code number is on the right (in the direction of travel). The ball sockets (55) must be installed in the same position again. 05.0906 - 2503