mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Note Since 04/88 the tolerance stages of piston and cylinder bore dia. have been identified with letters (hitherto figures, refer to data). As previously in the figures, the letters are also stamped in the mating face of the crankcase and in the piston crowns. Identification of tolerance stages Standard Model in’mlementation: 041’88 When performing repairs, ensure that the tolerance stage identification of piston and cylinder bore agrees. It is possible to install pistons with a code letter identification in cylinder bores with a digit identification if this tolerance stage identification agrees according to the table.

If, when performing repairs, no identical pairing is possible, reference can be made to the piston installation play of 0.016 - 0.040 mm to determine a suitable piston. 01.0904 - 11012 previous current