mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Measuring I I Measure the cleaned cylinder bores with an internal measuring device at measuring points 1, 2 and 3 in longitudinal direction A (piston pin axis) and in transverse direction B. With pistons installed, measuring point 3 is just above the piston, which must be at bottom dead center. - 3 A Longltudmal direction B Transverse direction a Top reversal point of 1st piston Measuring points 1 nng b Bottom dead center of piston c Bottom reversal point of 011 scraper rmg Chamfer the cylinder bores after boring. The material allowance for honing should be not more than 0.05 mm. 01 0904 - 1 lOi