mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

01-130 Removal and installation of steel balls in main oil gallery Preceding work: Removal of engine coolant pump (20-210). Removal of flywheel (03-410). Both steel balls . . . . . . . . . . . . . . . . . . . . . . . . . knock out together from back to front with a round steel bar (dia. 11 mm, approx. 500 mm long). If the rear ball moves into the cross passage to the oil filter, remove the oil filter to enable the ball to be removed. Bores . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . thoroughly clean in the area in which the steel balls are pressed in. Cup on fitting mandrel . . . , . . . . . . . . . . . . . . , . coat with grease and install cup.

steel ball into the Steel ball , I , , . , , , . , . . . , . . , . . . . , . . . . . . , position with the installation in each at front and rear as the mandrel. mandrel and knock far as the stop on Special tool 01.0904 . 130/l