Notes The main oil gallery is closed with steel balls, dia. 15 mm at the front, dia. 12 mm at the rear. When reconditioning the engine, the steel bails must be knocked out from the rear in order to clean the main oil galleries. Undamaged steel balls may be reused several times without machining the ball seat. Replace damaged steel balls. If a leak exists, reset steel balls approx. 1 mm (size is fixed on installation mandrel). Special tool 102 589 07 15 00. 9 Front steel ball (0 15 mm) Should the leaks not be repaired after this, knock out both steel balls and seal the main oil passage end in question with a screw plug. 10 Rear steel ball (0 12 mm) 01.0904 - 130/2