2 Pack grooves of the combination tap (9) of the tapping unit (1, ill. note) with grease and screw combination tap into the damaged thread. At the same time, press the guide bush (11) into the spark plug recess. Screw in combination tap far enough for the guide tube (12) to move up and be touching the stop ring (10). Caution! If the cylinder head is installed, unbolt combination tap after approx. each five turns, clean grooves of swarf and grease and again pack with grease. 3 Check length of the HELI-COIL thread insert (8). Use only the HELI-COIL inset-t with 9.1 mm block length. 4 Install HELI-COIL thread insert. To perform this step, insert HELI-COIL insert (8) into the tool (2, ill.
note) so that the bar (arrow) of the insert is facing the preload cartridge (16). Turn HELI-COIL insert with the turning spindle (13) far enough through the preload cartridge until the bar (arrow) is flush with the face of the preload cartridge. 01.0904 . 407/2