Install installation tool onto the tapped hole, hold jacket sleeve (15) tight and turn spindle for long enough until the stop ring (14) is touching the jacket sleeve. Note When installing the HELI-COIL thread insert, turn back jacket sleeve slightly (15) if it is jamming. 5 Break off bar (arrow) of the HELI-COIL thread insert. This is done by installing the sleeve (18) of the bar breaking unit (3, ill. note) over the bar, introducing the opened pliers (17) as far as the mark (arrow) into the sleeve and closing pliers. The serrated tooth lock (s) must engage. Turn sleeve to the left as far as the stop and hold tight. Move pliers slightly up and down and break off bar. Caution!
It is essential to remove a bar which may have dropped on the piston crown with a magnet. I by greasing the conical thread of the caulking tool 6 Caulk HELI-COIL thread insert. This is done (6) screwing caulking tool into the fitted HELI-COIL insert, tightening to 25 Nm and removing the caulking tool. 01 0904 - 40713