mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

7 Mill mounting seat for the copper seal (7). This is done by screwing in the guide mandrel (4) far enough for the stop collar (arrow) to be touching the tapped hole. Push milling cutter (5) over guide mandrel and mill the seat for the sealing ring. Always blow out the chips from time to time. Once the milling cutter is seated on the stop collar of the guide mandrel, the required milling depth is reached (no further cutting resistance). Once again thoroughly blow out spark plug recess before then removing the guide mandrel. Turn crankshaft several times with starter motor and contact handle in order to remove any chips which may have dropped onto the piston crown.

8 Place copper seal (7) into the milled mounting seat, screw in spark plug and tighten to 30 Nm. Note When performing this step, the tapered seat of the spark plug is pressed into the copper seal. 9 Loosen spark plug fully and tighten to 15 Nm. 01.0904 . 407/4