CTM-7 (5-89) 2R3; 015 13 llOSBIIJ AW1;R39502 R70;070300 967 020288 R70;070300 959 290188 3000 Series (HPR)-Hydraulic Pump Litho in U.S.A. 15-13 For DOUBLE BANK pump, perform Steps 7a and 7b. IMPORTANT: Double bank pump bearing cup removal in secondary housing will damage shims. DO NOT remove bearing cup if end play is within specification and cup does not appear to be worn or damaged. NOTE: On double bank pump with "8" drive, remove bearing cup and shims using a bearing cup puller. 7a. Drive end plug through secondary housing on double bank pump to remove bearing cup and shims. 7b. Increase number or size of shims in secondary housing to obtain correct specification. IMPORTANT:
Pistons must be Installed In their original bores If they are reused. 1. Remove piston assemblies. (See Remove and Inspect Piston Assemblies in this group.) 2. Remove secondary pump housing on double bank pump. 3. Remove inlet housing from primary pump housing. (See Remove and Install Inlet Housing in this group.) REMOVE AND INSTALL PUMP SHAFT AllTractorManuals.com