John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

AW1 ;R39491 R70;070300 953 020288 AW1;R39492 R70;070300 954 290188 CTM-7 (5-89) 2R3; 015 12 110589 3000 Series (HPR}-Hydraulic Pump Litho in U.S.A. 15-12 1. Remove piston assemblies. (See Remove and Inspect Piston Assemblies in this group.) NOTE: Use vice grip with curved jaw for better clamping. 2. Install vice grips as tightly as possible on pump shaft approximately 5/8 in. from housing hub. 3. Put a dial indicator base on pump housing and indicator contact point on steel ball placed in center of pump shaft. 4. Turn shaft back and forth while pushing down to align the tapered roller bearings inside pump housing. 6. Pry upward on vice grips using a long (3/4 in.

minimum) box-end wrench noting indicator reading. If end play is more than specification, check bearings for wear. Acceptable 0.025-0.100 mm (0.001-0.004 in.) 7. Increase number or size of shims in inlet housing on single bank pump to obtain correct specification. END PLAY SPECIFICATION CHECK SHAFT END PLAY 5. Zero the indicator. AllTractorManuals.com