John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

AWl;R39493 R70;070300 955 110588 AW1;R39490 R70;070300 1003 050288 CTM-7 (5-89) 2R3; 015 11 l105ecJ D-Coollng Pin E-Sprlng F-Plston A-Piston Plug B-o-Rlng c-5hleld 3000 Series (HPR)-Hydraulic Pump Litho in U.S.A. 15-11 IMPORTANT: Pistons must be Installed in their original bores If they are reused. Write numbers on piston plugs and discharge valve plugs for IdentifIcation. 1. Remove piston assemblies and put them in a parts tray to insure installation into the same bores from which they were removed. 3. Inspect face and skirt of pistons (F). Replace all pistons and pump housing(s) if metal transfer, galling. or scoring exists. IMPORTANT: All springs must be the same color code. 4.

Inspect springs (E) for excessive wear or damage to coils. Replace ALL piston springs as a set if springs are questionable. Free Length .... ....... ......... . . . . 77 mm (3.0 in .) (approximate) Test Length... .......... ... ....... .. ..... 54.4 mm at 241-295 N . (2.1 in. at 54-66 Ib force) 1. Install new O-rings and plastiC shields on piston plugs. IMPORTANT: To prevent damage to O-rings and shields, DO NOT use an air-operated wrench to tighten piston plugs; use a torque wrench. 2. Install piston assemblies. For easier assembly. turn pump shaft so piston installed is on the low side of cam. 2. Inspect piston plugs (A) for thread damage. 3. Tighten piston plugs to 200 N'm (150 Ib-ft).

NEW SPRING SPECIFICATION INSTALL PISTON ASSEMBLIES REMOVE AND INSPECT PISTON ASSEMBLIES AllTractorManuals.com