John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

t AW1;R39503 R70; 070300 9b8 020288 AW1;R39506 R70;070300 973 110589 AW1;R39512 R70;070300 981 050288 CTM-7 (5-89) 2R3; 015 20 110589 - ~ 3000 Series (HPR)-Hydraulic Pump Litho in U.S.A. 15-20 IMPORTANT: Bearing cups must be used with the same cone from which they were removed. IMPORTANT: Pump housing, bearing cones and cups must be replaced if bearing cups show signs of spinning. NOTE: Bearing cup removal from secondary housing on double bank pump will damage shims. New shims must be used if bearing cup is removed. 2. Put bearing cup on cone and turn slowly. If bearing makes a clicking noise or is sticking, clean and dip cone in clean hydraulic oil.

Turn again and replace bearing cone and cup if bearing continues to click or stick. 1. Inspect piston bores (A) in pump housing. Replace housing and pistons if scoring, galling or metal transfer exists. 2. Install each piston (8) into its bore so it extends approximately 13 mm (0.5 in.) into crankcase after visual inspection .. Pistons must slide smoothly and have no side play. If any side play is found, replace housing and pistons. NOTE Through drive shaft has an oil seal on both ends of 2. Remove oil seal(s) using a puller and slide hammer. REMOVE AND INSTALL OIL SEAL 1. Remove oil seal retaining snap ring(s). 1. Inspect bearing cups for damage.

INSPECT BEARING CUPS INSPECT PUMP HOUSING AllTractorManuals.com . pump.