AW1;R39508 R70;070300 958 040288 AW1 ;R39507 R70;070300 957 010288 CTM-7 (5-89) 2R3] 015 22 110569 D-Discharge Valve Plug E-O·Ring A-Valve Guide B-Discharge Valve C-Spring 3000 Series (HPR)-Hydraulic Pump Litho in U.S.A. 15-22 1. Remove inlet housing on single bank pump or secondary housing and inlet housing on double bank pump. (See Remove and Install Inlet Housing in this group.) IMPORTANT: Discharge valve assemblies must be in- stalled in their original bores. 2. Remove discharge valve assemblies and put them in a parts tray to insure installation into the same bores from which they were removed. 3. Inspect valve guide (A) for fatigue cracks at tabs and radius of legs. 4.
Inspect discharge valve plug (D) for thread damage or wear on stop. 5. Inspect springs (C) for excessive wear to coils and end surface of coils. Replace spring if wear is questionable. Free Length ....................... 12.7 mm (0.5 in.) (approximate) Test Length ..... . ............................ 9.3 mm at 17-24 N (0.4 in. at 4-5 Ib force) 6. Inspect valve (8) for erosion, pitting or excessive wear. Replace valve if wear is excessive. Discharge valve seat should also be checked for wear. (See Inspect, Remove and Install Discharge Valve Seats in this group.) 7. Install discharge valve assemblies with new O-rings. Tighten discharge valve plugs to 140 N'm (100 Ib-ft).
REMOVE, INSPECT AND INSTALL DISCHARGE VALVES NEW SPRING SPECIFICATION AllTractorManuals.com