CTM-7 (5-89) 2R3; 015 29 110589 AW1;R39616,R39620 R70;070300 1015 150589 AW1;R39698 R70;070300 1054 110589 3000 Series (HPR)-Hydraulic Pump Litho in U.S.A. 15·29 8. Inspect pressure compensator valve assembly. Valve (A) must slide freely in sleeve (8). Replace assembly if valve sticks or hangs up in sleeve. IMPORTANT: All pressure compensator parts must be thoroughly cleaned. All passage holes in parts must be open and clean. IMPORTANT: Valve (A) and sleeve (8) must be assem- bled correctly. Misassembly will cause pump malfunction. 9. Install new back-up (C) and O-ring (D) with back-up ring towards center of valve sleeve. 10.
Carefully install valve assembly into housing using DFRW52 Pressure Compensator Valve Installation and Removal Tool. Push until valve bottoms out in housing. Scribe line on tool should be approximately even with opening in inlet housing. A-Valve B-Sleeve C-Back-Up Ring O-O-Rlng 11. Install retaining plug (A) with new O-ring, spring (8) and valve (C) into inlet housing tightening retaining plug to 140 N·m (100 Ib-ft). 12. Install pressure adjusting assembly into inlet housing making sure spring guide protrusion is toward springes). IMPORTANT: Adjusting screw should be set to a mini- mum depth to prevent excessive dead- head pressure at start up. 13. Check pump deadhead pressure setting.
(See 3000 Series Operation and Tests, Group 115.) AllTractorManuals.com