Litho in U.S.A. 110-2 CTM-7 (5-89) 2R3; 110 02 110589 discharge pressure oil (P) to pass into the outlet gallery. At the end of stroke, discharge pressure oil in outlet gallery closes discharge valve (E). All discharge valves share a common outlet gallery in each pump housing. An orifice (H) is located between the crankcase and the inlet gallery. Any oil leakage past pistons is routed through orifice (H) to the inlet gallery. This flow allows for cooling and lubrication. The pump is designed to provide "on demand" discharge pressure oil (P) re- gardless of flow requirements. As demand for oil decreases system pressure increases.
This increased pressure closes crankcase outlet valve (M) and then opens pressure compensator valve (L) allowing high pressure oil to dump into crankcase (K) as deadhead pressure is reached. Increased pressure in the crank- case overcomes piston spring pressure and holds pistons (F) away from race (J), thereby destroking the pump.
RWH167 22 R70;070300 1040 110589 E-Dlscharge Valve F-Plston J-8earlng Race K-Crankcase N-Pressure Compensator Housing G-Inlet Source H-Qrlflce L-Pressure Compensator Valve M-Crankcase Outlet O-Pump Housing P-Dlscharge Pressure 011 Q-Crankcase Pressure Oil R-Inlet Pressure 011 I-Shaft ® @ CJ 2000 Series (PRJ-Operation and Tests Valve The 2000 Series radial piston pump is a variable displacement pump. Double banks are essentially two single bank pumps sharing a common shaft and pressure compensator. Designs vary slightly between serialized and non-serialized versions. Inlet oil (A) enters through inlet ports in the pump housing (0).
A common inlet gallery (C) in the pump housing provides oil to eight inlet valves (D). Pistons (F) radially surround an eccentric cam. The cam uses a bearing race (J) upon which the pistons ride. Behind each piston is a spring (some models have double springs) which pushes in and holds pistons against bearing race (J). As pump shaft (I) rotates, a low pressure cavity develops in the piston spring area during the downward stroke of piston. This low pressure allows inlet valve (D) to open, filling the piston cavity with oil. Inlet valves close at the end of inlet stroke of pistons. High pressure oil is developed as race pushes pistons outward.
As pressure increases, discharge valve (E) opens allowing HYDRAULIC PUMP OPERATION A-Inlet Source B-Hlgh Pressure Outlet C-Inlet Gallery D-Inlet Valve AllTractorManuals.com