John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

AW1 ;R37912, R39604 R70 ;070300 1095 260489 AW1 ;R39600 R70;070300 1090 260489 CTM-7 (5-89) 2R3; 010 22 110589 2000 Series (PRJ-Hydraulic Pump Litho in U.S.A. 10-22 NOTE' Not all shafts will have a sealing ring. Through drive shafts use sealing rings on both ends of shaft. NOTE: Use optional JDG493 Shaft Seal Sizer Tool (Aj to aid sealing ring installation. 4. Install JDG494 Spline Protector Tool (C) on pump shaft. 5. Carefully slide new sealing ring (8) over spline protector and down into groove on pump shaft making sure sealing ring does not twist. Use optional JDG493 sizing tool (A) to aid installation. NOTE: Optional JDG493 Sizing Tool may be used in place of hose clamp. 6.

Clamp sealing ring in groove using a hose clamp. Put shim stock between clamp and sealing ring to prevent sealing ring damage. Leave hose clamp in place approximately five minutes to allow sealing ring to set. NOTE: 26 needle rollers per race assembly are used on 100 cmS (6 in. 3j NON-SERIALIZED pumps. 25 or 50 needle rollers per race are used on all other double bank pumps. IMPORTANT: DO NOT use grease to hold needle rollers. Doing so can restrain roller movement and cause pump failure. Use only clean hydraulic oil. IMPORTANT: Three small spacers must be Installed between and on both ends of needle rollers for serialized pumps using double row needle rollers. 1.

Assemble shaft needle rollers using a rubber band to aid installation. (See procedure for single bank pump shaft assembly.) ASSEMBLE PUMP SHAFT- DOUBLE BANK PUMP AllTractorManuals.com