CTM-7 (5-89) 2Rl; 010 21 110589 AW1;R39600. R38497 R70;070300 1089 290188 2000 Series (PR)-Hydraulic Pump Litho in U.S.A. 10-21 NOTE: Standard drive shaft for serialized pump is shown. NOTE: 36 needle rollers are used on NON-SERIALIZED 40 cm 3 (2.4 in. 3) and 50 cm3 (3 in. 3) pumps. 25 are used on al/ other single bank pumps with single row needle rollers. 50 needle rollers are used on single bank pumps with double row needle rollers. IMPORTANT: DO NOT use grease to hold needle rollers. Doing so can restrain roller movement and cause pump failure. Use only clean hydraulic 011. IMPORTANT:
Three small spacers must be installed in between and on both ends of needle rollers for pumps using double row nee- dle rollers. 1. Assemble shaft needle rollers using a rubber band to aid installation. 2. Install spacers (8) on shaft (A) making sure spacers are properly aligned. IMPORTANT: Taper roller bearings must be pressed onto pump shaft even if shaft has not been disassembled. This assures correct pump shaft end play. 3. Install bearing cones (C) using a bearing press, making sure cone is pressed against shaft journal. ASSEMBLE PUMP SHAFT- SINGLE BANK PUMP AllTractorManuals.com