AW1;R37912. R39604 R70;070300 1095 260489 AW1;RW3528 R70;070300 1079 171287 CTM-7 (5-89) 2R3; 010 25 110589 2000 Series (PRJ-Hydraulic Pump Litho in U.S.A. 10·25 NOTE: Not all shafts will have a sealing ring. Through drive shafts use sealing rings on both ends of shaft. NOTE: Use optional JDG493 Shaft Seal Sizer Tool (Aj to aid sealing ring installation. 4. Install JDG494 Spline Protector Tool (C) on pump shaft. 5. Carefully slide new sealing ring (8) over spline protector and down into groove on pump shaft making sure sealing ring does not twist. Use optional JDG493 sizing tool (A) to aid installation. NOTE: Optional JDG493 Sizing Tool may be used in place of hose clamp. 6.
Clamp sealing ring in groove using a hose clamp. Put shim stock between clamp and sealing ring to prevent sealing ring damage. Leave hose clamp in place approximately five minutes to allow sealing ring to set. 1. Inspect piston bores (8) in pump housing (A). Replace housing and pistons if scoring, galling or metal transfer exists. 2. After visual inspection, install each piston (C) into its bore so it extends approximately 13 mm (0.5 in.) into crankcase. Pistons must slide smoothly and have no side play. If any side play is found, replace housing and pistons. INSPECT PUMP HOUSING AllTractorManuals.com