CTM-7 (5-89) AW1 ;R39503 R70;070300 1074 150589 AW1;R39947 R70;070300 1059 260489 2R3; 010 26 110589 2000 Series (PRJ-Hydraulic Pump IMPORTANT: Bearing cups must be used with the same cone from which they were removed. IMPORTANT: Pump housing, bearing cones and cups must be replaced if bearing cups show signs of spinning. NOTE: Save shims from secondary housing on double bank pump for reassembly. 1. Remove bearing cups using a slide hammer and a bearing cup puller. 2. Inspect bearing cups for damage. Put bearing cup on cone and turn slowly. If bearing makes a clicking noise or is sticking, clean and dip cone in clean hydraulic oil.
Turn again and replace if bearing continues to click or stick. NOTE: Prefe"ed method of changing oil seal is to have pump disassembled since shaft sealing ring (serial- ized pumpJ or quad ring and backup ring (non- serialized pump) in housing should be changed. Use this method ONL Y if pump can not be disassembled. 2. Put JDH35A Seal Puller from JDH32 Hydraulic Pump Seal Replacement Set on pump shaft. 3. Screw body (A) of puller into gland of oil seal as far as possible. Litho in U.S.A. 10-26 1. Remove oil seal retaining snap ring in housing. REMOVE AND INSTALL OIL SEAL- PUMP ASSEMBLED 4. Remove seal by tightening screw in puller. INSPECT BEARING CUPS AllTractorManuals.com