AWl;R39752 R70;070300 10B3 1705B9 CTM-7 (5-89) 2R3: 010 27 11058' AWl;R3994B R70;070300 1060 OB02BB . AWl;R39751 R70;070300 10B5 2901BB 2000 Series (PR)-Hydraulic Pump Litho in U.S.A. 10·27 IMPORTANT: DO NOT push all seal beyond Inner edge of snap ring groove. Doing so can close drain passage and cause an all seal failure. 5. Put JDG494 Spline Protector on shaft to prevent seal damage. 6. Apply petroleum jelly to lips of new oil seal siding seal with lip (spring side) toward inside of pump down over spline protector. 7. Remove spline protector and use JDH31 A Seal Driver (A) from JDH32 Hydraulic Pump Seal Replacement Set to install oil seal.
Oil seal should be installed just far enough to install retaining snap ring. NOTE: Through drive pump shaft uses oil seals on both ends of pump shaft. For NON-SERIALIZED single bank pump, perform Steps 2a and 2b. 2a. Remove and discard backup ring (A) and quad ring (8). 2b. Install new backup ring (A) and quad ring (8) into groove inside pump housing. Quad ring should be toward inside of housing. 2. Remove oil seal using a puller and slide hammer. REMOVE AND INSTALL OIL SEAL- PUMP DISASSEMBLED 1. Remove oil seal retaining snap ring. 8. Install retaining snap ring. AllTractorManuals.com