John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

CTM-7 (5-89) 2R3; 010 28 110589 AW1;T85279 R70;070300 1087 260489 2000 Series (PRJ-Hydraulic Pump Litho in U.S.A. 10-28 IMPORTANT: DO NOT push oil seal beyond inner edge of snap ring groove. Doing so can close drain passage and cause an oil seal failure. NOTE: Use a 1-15/16 in. disk from a Bushing, Bearing and Seal Driver Set to aid installation. 3. Install oil seal (A) with lip (spring side) toward inside of pump housing making sure drain passage is not blocked. 4. Apply petroleum jelly to lips of oil seal for lubrication when shaft is installed. 2. Check inlet valves for free valve movement and valve lift. If valves are not broken and move freely, do not remove.

INSPECT, REMOVE AND INSTALL INLET VALVES 5. Install retaining snap ring. 1. Remove inlet valve plugs. AllTractorManuals.com