AWl;R39775 R70;070300 1134 080288 AWl;R39949 R70;070300 1113 100589 CTM-7 (5-89) 2R); 010 )5 110589 2000 Series (PR)-Hydraulic Pump Litho in U.S.A. 10-35 9. Install manual destroke or plug with new O-rings into pressure compensator housing. 10. Install pressure compensator valve (H) into sleeve in housing. 11 . Install long spring guide (F) with spring (0) or short spring guide (G) with spring (E). NOTE' Copper washer (8) is used with spring (0) and spring guide (F), and thick washer (C) is used with spring (E) and spring guide (G). Some applications may use both washer (8 and C). 12. Install adjusting screw and bushing assembly (A) with copper washer (8) or thick washer (C).
A-Adjusting Screw and Bushing B-Copper Washer C- Thick Washer D-Sprlng E-Sprlng F-Sprlng Guide G-Sprlng Guide H-Pressure Compensator Valve 1. Slowly loosen pressure adjusting screw (A) to relieve any crankcase pressure. NOTE: Not all pressure adjusting assemblies will use the sma/ler inner spring (0). 3. Inspect springs (C and 0) and spring guide (E) for wear or damage. Spring (C) Free Length ........... ... ... ... .. 97 mm (3.8 in.) (approximate) Test Length ........... . .. . . . .... .. . . ... 78 mm at 1340-1640 N (3.1 in at 300-30 Ib force) Spring (D) Free Length ... . . . . ........... .. .. 92 mm (3.6 in .) (approximate) Test Length . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . 79 mm at 495-605 N (3.1 in. at 110-135 Ib force) DISASSEMBLE, INSPECT AND ASSEMBLE PRESSURE COMPENSATOR VALVE- THROUGH DRIVE PUMP 2. Remove adjusting screw and sleeve assembly (8). NEW SPRING SPECIFICATION AllTractorManuals.com