AW1;R37b39 R70;070300 1123 080288 AW1;R39771 R70;070300 1127 150589 AW1;T85474 R70;070300 1131 080288 CTM-7 (5-89) 2R3; 010 34 110589 2000 Series (PR)-Hydraulic Pump Litho in U.S.A. 10-34 5. Inspect pressure compensator valve assembly. Valve (0) must move freely in bore (C). Valve face (A) and seat (8) must be free of pits or nicks. Replace valve and sleeve if drag or damage exists. Valve OD ...................................... 6.759-6.769 mm (0.2661-0.2665 in.) Sleeve ID (Top End) ..... .... ................. 6.7740-6.7900 mm (0.2667-0.2673 in.) A-Valve Face B-Valve Seat c-5leeve Bore D-Valve IMPORTANT: All pressure compensator valve parts must be thoroughly cleaned.
All passage holes In parts must be open and clean. NOTE' Cutaway section of serialized pressure compensator housing is shown. 7. Install new O-ring (A) (and backup ring (8) in serialized pump) through manual destroke port (C) in pressure com- pensator housing. Use an O-ring seal hook to aid installation. IMPORTANT: DO NOT use a punch to install pressure compensator sleeve. Damage could oc- cur to the sleeve and cause sticking. 8. Carefully install pressure compensator valve sleeve through adjusting screw port making sure sleeve seating surfaces are not damaged. Push sleeve against manual destroke using a wood or brass dowel. 6. Replace O-ring and backup ring on sleeve.
NEW PART SPECIFICATION AllTractorManuals.com