AW1;R397b4 R70;070300 1114 100589 AW1;R37715 R70;070300 1122 090288 CTM-7 (5-89) 2R3; 010 33 110589 2000 Series (PR)-Hydraulic Pump Litho in U.S.A. 10-33 NOTE' Two manual destroke screws and two spring and spring guide assemblies are shown. IMPORTANT: Remove adjusting screw and bushing assembly (A) prior to removing manual destroke screw (or plug If manual de- stroke Is not used). Pressure compensa- tor valve sleeve packings will be dam- aged if adjusting screw and bushing as- sembly are not removed first. 1. Remove adjusting screw and bushing assembly (A), special washer(s) (B), spring (C or D), spring guide (E or F) and stroke control valve (G). NOTE:
Spring (C) uses long spring guide (E) and spring (0) uses short spring guide (F). 2. Inspect spring (C or D) for excessive wear or damage. Spring (C) Free Length ...................... 92 mm (3.6 in.) (approximate) Test Length .............................. 84 mm at 556-690 N (3.3 in. at 125-155 Ib force) Spring (0) Free Length ...................... 90 mm (3.5 in.) (approximate) Test Length. . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 75 mm at 801-979 N (3.0 in. at 180-220 Ib force) E-Sprlng Guide F-Sprlng Guide G-Pressure Compensator Valve H-Manual Oestroke Screws NOTE: Standard drive single bank pressure compensator housing is shown. IMPORTANT:
DO NOT use a punch to remove pressure compensator valve sleeve (and crank- case outlet valve sleeve or fixed orifice sleeve In non-serialized pumps).Sleeve(s) could be damaged and cause sticking. 4. Carefully remove pressure compensator valve sleeve using a wood or brass dowel. Remove from manual destroke opening toward adjusting screw opening. DISASSEMBLE, INSPECT AND ASSEMBLE PRESSURE COMPENSATOR VALVE- STD. AND AUX. GEAR DRIVE PUMPS NEW SPRING SPECIFICATION 3. Inspect spring guide (E or F) for wear. A-AdJusUng Screw and Bushing B-Speclal Washers C-Sprlng D-Sprlng AllTractorManuals.com