Cummins — 4021330

Air Compressor C8.3 Industrial Page 5-8 Section 5 - Maintenance Procedures at 250 Hours or 3 Months Air Compressor Maintenance Check NOTE: Depending on application, all engines will possibly not be equipped with an air compressor. Inspect compressor housing for cracks and damage. Inspect hydraulic pump couplings for cracks, wear, or damage (if equipped). Inspect air plumbing for splits or cracks. Inspect the air compressor mounting nuts, including support bracket, for loose or damaged hardware. Operate the engine and check for correct compressor operation and air, oil, and coolant leaks. Torque Value: Mounting 18 mm 77 N•m [ 57 ft-lb ] Torque Value:

Bracket 10 mm 45 N•m [ 33 ft-lb ] Preparatory Steps WARNING When using a steam cleaner, wear safety glasses or a face shield as well as protective clothing. Hot steam can cause serious personal injury. Compressed air used for cleaning should not exceed 207 kPa [30 psi]. Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING WARNING Coolant is toxic. Keep away from pets and children. If not reused, dispose of in accordance with local environmental regulations. Do not remove the pressure cap from a hot engine. Wait until the temperature is below 50°C [120°F] before removing the pressure cap.

Heated coolant spray or steam can cause personal injury. NOTE: The illustrations shown will be of the QE model single-cylinder air compressor. Differences in procedures for QE and HD model Cummins air compressors will be shown where necessary. WARNING Drain the engine coolant. Refer to Procedure 008-018. Remove the coolant lines from the air compressor. NOTE: If the air compressor does not have a liquid- cooled cylinder head, then this step is not necessary. Use steam to clean the air compressor. Dry with compressed air. Remove the hydraulic pump, if equipped. Refer to Procedure 009-016.