C8.3 Industrial Radiator Pressure Cap Section 5 - Maintenance Procedures at 250 Hours or 3 Months Page 5-9 Finishing Steps Fill the engine cooling system (liquid-cooled air compressor only ). Refer to Procedure 008-018. Operate the engine and check for leaks. With the air compressor pumping between 550 to 690 kPa [80 to 100 psi], use a solution of soapy water to check for air leaks. Operate the engine to activate the air compressor. Radiator Pressure Cap Pressure Test The system is designed to use a pressure cap to prevent boiling of the coolant. Different caps are specified for the two recommended systems: Pressure-test the cooling system pressure cap.
The pressure cap must seal within 14 kPa [2 psi] of the value stated on the cap, or it must be replaced. An incorrect or malfunctioning cap can result in the loss of coolant and the engine running hot. System Cap A - 104°C [220°F] 103 kPa [15 psi] B - 99°C [210°F] 48 kPa [7 psi]