C8.3 Industrial Fuel-Water Separator Section 6 - Maintenance Procedures at 300 Hours or 1 Year Page 6-3 The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious personal injury. Wear gloves and protective clothing. WARNING 17-mm (PES.A, PES.MW) and 19-mm (PES.P) Wrenches Loosen the fittings at the injectors, and crank the engine to allow entrapped air to vent from the lines. Tighten the fittings. WARNING It is necessary to put the engine in the run position. Because the engine could start, be sure to follow all the safety precautions. Use the normal engine starting procedure. Start the engine and vent one line at a time until the engine runs smoothly. NOTE:
Do not engage the starter for more than 30 seconds each time when it is used to vent the system: Wait 2 minutes between engagements. Fuel-Water Separator Drain WARNING Drain the water-fuel separator into a container and dispose of in accordance with local environmental regulations. Cummins Inc. requires a fuel-water separator or fuel filter be installed in the fuel supply system. Drain the water and sediment from the separator daily. Canister Type Shut off the engine. Pull up on the drain valve lever until fluid drains out of the drain tube. Drain the filter sump until clear fuel is visible. Push up on the drain valve until fluid drains out of the drain tube.