C8.3 Industrial Lubricating Oil and Filters Section 6 - Maintenance Procedures at 300 Hours or 1 Year Page 6-5 To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. WARNING Use a container that can hold at least 25 liters [26 qt] of lubricating oil. Operate the engine until the water temperature reaches 60°C [140°F]. Shut off the engine . Remove the lubricating oil drain plug. NOTE: Some applications such as marine, industrial, or generator drives have limited accessibility to oil drains. Alternate methods are available for removing oil such as pump out systems. Check with local dealer or distributor for information.
Remove Clean the area around the lubricating oil filter head. Remove the filter. Clean the gasket surface of the filter head. The o-ring can stick on the filter head. Make sure it is removed. Install Fill the filters with clean lubricating oil before installation. NOTE: The LF3000 lubricating oil filter has two gaskets. Lubricate both gaskets. Apply a light film of oil to the gasket sealing surface before installing the filters. Mechanical overtightening can distort the threads or damage the lubricating oil filter element seal. CAUTION If the filter canister is damaged in any way, do not use it. Dents or scrapes can lead to a rupture or premature failure of the filter.
CAUTION Install the lubricating oil filter as specified by the filter manufacturer.