Cummins — 4021330

C8.3 Industrial Coolant Filter Section 6 - Maintenance Procedures at 300 Hours or 1 Year Page 6-7 Stop the engine. Wait approximately 15 minutes to let the lubricating oil drain from the upper parts of the engine. Check the level again. Add oil as necessary to bring the oil level to the H (high) mark on the dipstick. Coolant Filter Remove WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury Turn the shutoff valve to the OFF position by rotating the knob from vertical to horizontal in the direction shown. Remove and discard the coolant filter.

Clean Clean the gasket surface.