Air Intake Piping C8.3 Industrial Page 6-20 Section 6 - Maintenance Procedures at 300 Hours or 1 Year Air Cleaner Assembly (Engine- Mounted) Maintenance Check CAUTION Holes, loose-end seals, dented sealing surfaces, and other forms of damage render the air cleaner inoperative and require immediate replacement. Elements that have been cleaned several times will finally clog and airflow to the engine will be restricted. After cleaning the element, check the intake air restriction as previously described. Replace the element, if necessary. CAUTION To avoid damage to the element, pull the cover and the element straight out when removing them from the air cleaner housing.
Unsnap the latches (4) that secure the cover (1) to the air cleaner housing (5). Remove the cover (1). Pull the element (3) out of the housing. Remove the o-ring (2) from the cover (1) and inspect. If the o-ring (2) is damaged, it must be replaced. Install the air cleaner element (3) into the housing. Make sure that the o-ring (2) is seated properly on the cover (1). Install the cover (1). Snap the latches (4) to secure the cover (1). Air Intake Piping Maintenance Check Inspect the intake piping daily for wear points and damage to piping, loose clamps, and punctures that can damage the engine.
Replace damaged pipes and tighten loose clamps, as necessary, to prevent the air system from leaking. Torque Value: 8 N•m [ 71 in-lb ] Check for corrosion under the clamps and hoses of the intake system piping. Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean, as required.