C8.3 Industrial Aftercooler Assembly (Sea Water) Section 6 - Maintenance Procedures at 300 Hours or 1 Year Page 6-19 Install the sea water inlet and outlet hoses on the aftercooler. Torque Value: Constant Torque Type of Clamps 5 N•m [ 44 in-lb ] Inspect the zinc plug. If it has eroded over 50 percent, replace it. NOTE: Do not use thread sealant in the plugs. They must be grounded to component to function properly. Install zinc plugs in aftercooler. Torque Value: 22 N•m [ 196 in-lb ] Open the sea water inlet valve. Erosion Limits New A = Approximately 19 mm [0.75 in] 51 mm [2 in] B = Approximately 6.4 mm [0.25 in] 16 mm [0.63 in]