Cummins — 4021330

Aftercooler Assembly (Sea Water) C8.3 Industrial Page 6-18 Section 6 - Maintenance Procedures at 300 Hours or 1 Year Aftercooler Assembly (Sea Water) Flush In any flushing operation, it is critical that the air filter element or turbocharger inlet not be exposed to moisture. Equipment damage can result. CAUTION The sea water aftercooler is used to cool the intake air to the engine. Because sea water runs through the core tubes, it must be flushed with fresh water at least once each year. Shut off the sea water supply valve on the vessel hull. Remove both zinc plugs from the aftercooler to drain the aftercooler.

If the zinc plug should break off in the aftercooler during removal, all pieces must be removed. To make certain all pieces are removed, it will possibly be necessary to disassemble some components. Remove the sea water inlet and outlet hose from the aftercooler. Use clean low-pressure water such as a garden hose connected to city water. Connect the hose to the sea water outlet to allow the water to backflush the system. This will remove and flush away any loose debris.