C8.3 Industrial Sea Water Pump Section 6 - Maintenance Procedures at 300 Hours or 1 Year Page 6-17 Install the rubber impeller cap into the center hub of the impeller. Install a new gasket, cover plate, and capscrews. Tighten the capscrews. Torque Value: 24 N•m [ 212 in-lb ] Finishing Steps Install the inlet and outlet hose to the pump. Open the sea water inlet valve and check for leaks. If you have a wet exhaust system, start the engine and check for water flow from the exhaust. Also, check the sea water pump and plumbing for leaks.