Cummins — 4021330

C8.3 Industrial Overhead Set Section 8 - Maintenance Procedures at 600 Hours or 2 Years Page 8-5 NOTE: If the seal is not damaged, it can be used again. If the seal is damaged, install a new seal. Install the rubber seal into the groove in the valve cover. Start the installation at the overlap area shown in the illustration. Do not stretch the rubber seal. If the seal has more overlap than shown in the illustration, trim the length to provide the correct overlap. Install new sealing o-rings on the capscrews. Install the valve cover and wastegate sensing tube. Torque Value: 24 N•m [ 212 in-lb ] Install the crankcase vent tube, and secure with the support clamps and hose clamp. Torque Value:

A = 24 N•m [212 in-lb]. B = 43 N•m [32 in-lb]. Install the air crossover tube and any other parts previously removed to gain access to the valve cover.