Overhead Set C8.3 Industrial Page 8-4 Section 8 - Maintenance Procedures at 600 Hours or 2 Years Intake clearance: 0.30 mm [0.012 in]. Exhaust clearance: 0.61 mm [0.024 in]. Check/set valves with engine cold - below 60°C [140°F]. NOTE: The clearance is correct when some resistance is “felt” when the feeler gauge is slipped between the valve stem and the rocker lever. Locate top dead center for cylinder Number 1. Check/adjust the valves indicated for STEP A (I = intake; E = exhaust). After tightening the rocker lever locknut, check the valve clearance to make sure the valve clearance has not changed. Torque Value:
24 N•m [ 212 in-lb ] Be sure the engine timing pin is disengaged to prevent damage to the engine timing pin. CAUTION Mark vibration damper and rotate the crankshaft 360 degrees. After tightening the rocker lever locknut, check the valve clearance to make sure the valve clearance has not changed. Set the valves indicated for STEP B. Torque Value: 24 N•m [ 212 in-lb ]