Cummins — 4021330

C8.3 Industrial Overhead Set Section 8 - Maintenance Procedures at 600 Hours or 2 Years Page 8-3 Remove valve cover. Locate top dead center for cylinder Number 1 by rotating the crankshaft slowly while pressing on the engine timing pin. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 127-cm [1/2-in] ratchet or breaker bar. When the engine timing pin engages the hole in the camshaft gear, cylinder Number 1 is at top dead center on the compression stroke. Be sure to disengage the engine timing pin after locating top dead center to prevent damage to the engine timing pin. CAUTION