C8.3 Industrial Cooling System Section 8 - Maintenance Procedures at 600 Hours or 2 Years Page 8-7 NOTE: Do not install the radiator cap. The engine is to be operated without the cap for this process. Fill the system with a mixture of sodium carbonate and water (or a commercially available equivalent). Use 0.5 kg [1 lb] of sodium carbonate for every 23 liters [6 gal] of water. WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Operate the engine for 5 minutes with the coolant temperature above 80°C [176°F]. Shut the engine off, and drain the cooling system.
CAUTION The system must be filled properly to prevent air locks. During filling, air must be purged from the engine coolant passages. Be sure to open the petcock on the aftercooler for aftercooled engines. Wait 2 to 3 minutes to allow air to be vented; then add water to bring the level to the top. Fill the cooling system with high-quality water. Do not install the radiator cap or the new coolant filter. Operate the engine for 5 minutes with the coolant temperature above 80°C [176°F]. Shut the engine off, and drain the cooling system. If the water being drained is still dirty, the system must be flushed again until the water is clean.