Cummins — 4021330

Overhead Set C8.3 Industrial Page 9-2 Section 9 - Maintenance Procedures at 1000 Hours or 1 Year Locate top dead center for cylinder Number 1 by rotating the crankshaft slowly while pressing on the engine timing pin. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 127-cm [1/2-in] ratchet or breaker bar. When the engine timing pin engages the hole in the camshaft gear, cylinder Number 1 is at top dead center on the compression stroke. Be sure to disengage the engine timing pin after locating top dead center to prevent damage to the engine timing pin. CAUTION Intake clearance: 0.30 mm [0.012 in].

Exhaust clearance: 0.61 mm [0.024 in]. Check/set valves with engine cold - below 60°C [140°F]. NOTE: The clearance is correct when some resistance is “felt” when the feeler gauge is slipped between the valve stem and the rocker lever.