Cummins — 4021330

C8.3 Industrial Overhead Set Section 9 - Maintenance Procedures at 1000 Hours or 1 Year Page 9-3 Locate top dead center for cylinder Number 1. Check/adjust the valves indicated for STEP A (I = intake; E = exhaust). After tightening the rocker lever locknut, check the valve clearance to make sure the valve clearance has not changed. Torque Value: 24 N•m [ 212 in-lb ] CAUTION Be sure the engine timing pin is disengaged to prevent damage to the engine timing pin. Mark vibration damper and rotate the crankshaft 360 degrees. Set the valves indicated for STEP B. After tightening the rocker lever locknut, check the valve clearance to make sure the valve clearance has not changed. Torque Value:

24 N•m [ 212 in-lb ] NOTE: If the seal is not damaged, it can be used again. If the seal is damaged, install a new seal. Install the rubber seal into the groove in the valve cover. Start the installation at the overlap area shown in the illustration. Do not stretch the rubber seal. If the seal has more overlap than shown in the illustration, trim the length to provide the correct overlap.