Cooling Fan Belt Tensioner C8.3 Industrial Page 9-4 Section 9 - Maintenance Procedures at 1000 Hours or 1 Year Install new sealing o-rings on the capscrews. Install the valve cover and wastegate sensing tube. Torque Value: 24 N•m [ 212 in-lb ] Install the crankcase vent tube, and secure with the support clamps and hose clamp. Torque Value: A = 24 N•m [212 in-lb]. B = 43 N•m [32 in-lb]. Install the air crossover tube and any other parts previously removed to gain access to the valve cover. Cooling Fan Belt Tensioner Maintenance Check Every 48,000 km [30,000 mi], 1000 hours, or 1 year, whichever occurs first, inspect the automatic belt tensioner.
With the engine turned off, check that neither the top nor bottom tensioner arm stop is touching the cast boss on the tensioner body. If either of the stops is touching a boss, the alternator belt must be replaced. Check to make sure the correct belt part number is being used if either condition exists.