C8.3 Industrial Vibration Damper, Rubber Section 10 - Maintenance Procedures at 2000 Hours or 2 Years Page 10-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Vibration Damper, Rubber Inspect Check the index lines (A) in the vibration damper hub (B) and the inertia member (C). If the lines are more than 1.59 mm [1/16 in] out of alignment, replace the vibration damper. Inspect the rubber member for deterioration.
If pieces of rubber are missing or if the elastic member is more than 3.18 mm [1/8 in] below the metal surface, replace the damper. Look for forward movement of the damper ring on the hub. Replace the vibration damper if any movement is detected. For vibration damper location, refer to Engine Diagrams in Engine Identification (Section E).