Cooling System C8.3 Industrial Page 10-2 Section 10 - Maintenance Procedures at 2000 Hours or 2 Years Vibration Damper, Viscous Inspect The silicone fluid in the vibration damper will become solid after extended service and will make the damper inoperative. An inoperative vibration damper can cause major engine or drivetrain failures. CAUTION Check the vibration damper for evidence of fluid loss, dents, and wobble. Inspect the vibration damper thickness for any deformation or raising of the damper cover plate. If any of these conditions are identified, contact your local Cummins Authorized Repair Location to replace the vibration damper.
For vibration damper location, refer to Engine Diagrams in Engine Identification (Section E). Cooling System Drain Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Drain the cooling system by opening the drain valve on the radiator and removing the plug in the bottom of the water inlet hose. A drain pan with a capacity of 19 liters [5 gal] will be adequate for most applications.