C8.3 Industrial Cooling System Section 10 - Maintenance Procedures at 2000 Hours or 2 Years Page 10-3 Check for damaged hoses and loose or damaged hose clamps. Replace as required. Check the radiator for leaks, damage, and buildup of dirt. Clean and replace as required. Flush CAUTION The system must be filled properly to prevent air locks. During filling, air must be purged from the engine coolant passages. Be sure to open the petcock on the aftercooler for aftercooled engines. Wait 2 to 3 minutes to allow air to be vented; then add mixture to bring the level to the top. Adequate venting is provided for a fill rate of 19 liters [5 gal] per minute. NOTE: Do not install the radiator cap.
The engine is to be operated without the cap for this process. Fill the system with a mixture of sodium carbonate and water (or a commercially available equivalent). Use 0.5 kg [1 lb] of sodium carbonate for every 23 liters [6 gal] of water. Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. WARNING Operate the engine for 5 minutes with the coolant temperature above 80°C [176°F]. Shut the engine off, and drain the cooling system.