C8.3 Industrial Air Compressor Discharge Lines Section 10 - Maintenance Procedures at 2000 Hours or 2 Years Page 10-5 Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50° C [120° F] before removing the pressure cap. Heated coolant spray of steam can cause personal injury. WARNING Install the pressure cap. Operate the engine until the coolant reaches a temperature of 80°C [180°F], and check for coolant leaks. Check the coolant level again to make sure the system is full of coolant or that the coolant level has risen to the hot level in the recovery bottle on the system, if so equipped.
Air Compressor Discharge Lines General Information All air compressors have a small amount of lubricating oil carryover that lubricates the piston rings and moving parts. When this lubricating oil is exposed to normal air compressor operating temperatures over time, the lubricating oil will form varnish or carbon deposits. If the following maintenance check are not performed, the air compressor piston rings will wear and not seal correctly. Maintenance Check Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING Shut off the engine. Open the drain valve on the wet tank to release the system air pressure.
Remove the air compressor discharge line from the air compressor. Location of the air compressor discharge line can be found in Flow Diagram, Compressed Air System in System Diagrams (Section D).