Cummins — 4021330

Air in Fuel C8.3 Industrial Page A-4 Section A - Adjustment, Repair, and Replacement Since the fuel lift pump provides positive pressure through the fuel filter and supply line to the fuel injection pump, loose connections or defective seals can show as a fuel leak, not as an air leak. NOTE: If an excessive amount of air has entered into the system, the system will need to be vented. Loosen the return banjo fitting on the fuel lift pump. Run the fuel lift pump until all the air has been vented. When all the air has been vented, retighten the fitting. NOTE: To run the fuel pump for 25 seconds, crank the engine for a split second, and leave the key in the ON position.

If air continues to bubble out of the system for several minutes, then an air leak is present. An often overlooked source from which air can enter the fuel system is between the inlet of the fuel transfer pump and the suction tube in the tank. Fuel tanks that have the outlet fitting at the top will have a suction tube that extends to the bottom of the tank. Cracks or pin holes in the weld that join the tube to the fitting can let air enter the fuel system. Also, check to make sure all the fittings from the fuel supply line on the tank to the inlet of the fuel transfer pump are tight. Use a sight glass at the fuel lift pump inlet to check for air in the fuel supply lines.

Since the fuel pump provides a positive pressure through the fuel filter and supply line to the fuel injection pump, loose connections or defective seals should show as a fuel leak, not as an air leak.