Cummins — 4021330

C8.3 Industrial Charge-Air Cooler Section A - Adjustment, Repair, and Replacement Page A-13 Charge-Air Cooler General Information The long-term integrity of the charge-air cooler system is the responsibility of the vehicle and component manufacturers; however, the following can be checked by any Cummins® Authorized Repair Facility. NOTE: If the engine experiences turbocharger damage or any other occasion where oil or debris is put into the charge-air cooler, the charge-air cooler must be cleaned. Initial Check Inspect the charge-air cooler for cracks, holes, and other damage. Inspect the tubes, fins, and welds for tears, breaks, or other damage.

If any damage causes the charge-air cooler to fail the air leak check, the charge-air cooler must be replaced. Inspect the charge-air cooler plumbing for cracks and damage. Remove Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Drain the coolant.

Remove the charge air cooler plumbing and cooler. Refer to original equipment manufacturer (OEM) service manual. Use compressed air to clean debris from the outside of the charge-air cooler.