Cummins — 4021330

Charge-Air Cooler C8.3 Industrial Page A-14 Section A - Adjustment, Repair, and Replacement Clean When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING WARNING Some solvents are flammable and toxic. Read the manufacturer's instructions before using. CAUTION Do not use caustic cleaners to clean the charge air cooler. Damage to the charge air cooler will result. Flush the charge-air cooler internally with solvent in the opposite direction of normal airflow.

Shake the charge-air cooler and lightly tap on the end tanks with a rubber mallet to dislodge trapped debris. Continue flushing until all debris or oil is removed (i.e., the water runs clear). NOTE: Make sure that the tubes are in the vertical direction when flushing. If the debris can not be totally removed from the charge- air cooler, the charge-air cooler must be replaced. When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING Wear appropriate eye and face protection when using compressed air.

Flying debris and dirt can cause personal injury. WARNING The charge air cooler must be rinsed, dried, and cleaned of solvent, oil, and debris, or engine damage will result. CAUTION After the charge-air cooler has been thoroughly cleaned of all oil and debris with solvent, wash the charge-air cooler internally with hot, soapy water to remove the remaining solvent. Rinse thoroughly with clean water. Blow compressed air through the inside of the charge-air cooler in the opposite direction of normal airflow until the charge-air cooler is dry internally.