C8.3 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-5 Air Compressor Noise is Excessive Cause Correction STEP 1 Carbon buildup is excessive in the air discharge Check for carbon buildup. Replace the air compressor discharge line and cylinder head assembly if necessary. Refer to the OEM service manual. line, downstream air valves, or cylinder head ............. OK Go To Next Step STEP 2 Air compressor is sending air pulses into the air tanks ............. Install a ping tank between the air dryer and the wet tank. Refer to the manufacturer's instructions.
OK Go To Next Step For all models, check for ice in low spots of the air discharge line, dryer inlet, and elbow fittings. On Holset® models, also check the Econ valve (if equipped). Refer to the OEM service manual. STEP 3 Ice buildup in the air system components ............. OK Go To Next Step STEP 4 Contact a Cummins® Authorized Repair Facility