Troubleshooting Symptoms Charts C8.3 Industrial Page TS-6 Section TS - Troubleshooting Symptoms Air Compressor Pumping Excess Lubricating Oil into the Air System Cause Correction STEP 1 Lubricating oil drain interval is excessive ............. Verify the correct lubricating oil drain interval. Refer to Procedure 102-002 (Maintenance Schedule) in Section 2. OK Go To Next Step Replace the air compressor air cleaner (if installed). Check the air intake piping. Check engine air intake restriction if the air compressor inlet is plumbed to the vehicle or equipment intake system. Refer to Procedure 010-059 (Air Cleaner Restriction) in Section 4.
STEP 2 Air intake system restriction to air compressor is ............. excessive OK Go To Next Step Replace the desiccant cartridge on the Turbo/CR 2000 air dryer. Refer to the OEM service manual. Check the air compressor duty cycle. Install a larger air compressor, if necessary. Refer to an Authorized Cummins Repair Facility. STEP 3 Air compressor pumping time is excessive ............. OK Go To Next Step STEP 4 Carbon buildup is excessive in the air discharge Check for carbon buildup. Replace the air compressor discharge line, if necessary. Refer to the OEM service manual. line, check valve, or cylinder head .............
OK Go To Next Step STEP 5 Contact a Cummins® Authorized Repair Facility