Cummins — 4021330

Troubleshooting Symptoms Charts C8.3 Industrial Page TS-12 Section TS - Troubleshooting Symptoms Coolant Loss - External Cause Correction STEP 1 Coolant level is below specification ............. Inspect the engine and cooling system for external coolant leaks. Repair if necessary. Add coolant. Refer to the OEM service manual. OK Go To Next Step Inspect the engine for coolant leaking from hoses, draincocks, water manifold, jumper tubes, expansion and pipe plugs, fittings, radiator core, air compressor and cylinder head gaskets, lubricating oil cooler, water pump seal, cylinder block, and OEM-mounted components that have coolant flow. Refer to Procedure 008-066 (Coolant Level) in Section 3.

STEP 2 External coolant leak ............. OK Go To Next Step STEP 3 Radiator cap is not correct, is malfunctioning, or has low-pressure rating ............. Check the radiator pressure cap. Refer to the OEM service manual. OK Go To Next Step STEP 4 Cooling system hose is collapsed, restricted, or ............. Inspect the hoses. Refer to Procedure 008-086 (Cooling System Hoses) in Section 4. leaking OK Go To Next Step STEP 5 Coolant fill line is restricted or obstructed ............. Check the coolant fill line for restrictions or obstructions. Refer to Procedure 008-066 (Coolant Level) in Section 3. OK Go To Next Step Drain and flush the cooling system.

Fill with correct mixture of antifreeze and water. Refer to Procedure 008-046 (Supplemental Coolant Additive (SCA) and Antifreeze Concentration) in Section 7. STEP 6 Coolant is rusty and has debris ............. OK Go To Next Step STEP 7 Engine is overheating ............. Refer to the Coolant Temperature Above Normal symptom tree. OK Go To Next Step STEP 8 Contact a Cummins® Authorized Repair Facility